SANDPIPER S20B1A1EANS000 2-Inch Aluminum Diaphragm Pump

2-Inch Aluminum AODD Pump

The SANDPIPER S20B1A1EANS000 is a complete S20 metallic air-operated double-diaphragm pump with 2-inch female NPT liquid connections. This standard configuration uses aluminum wetted components, Santoprene diaphragms and check balls, EPDM seats and a painted aluminum air section.

The S20 metallic series is intended for industrial transfer duties involving compatible liquids, moderate abrasives and suspended solids. Its ESADS+ air distribution system can be serviced externally, and the air valve does not require added lubrication.

Конфигурация модели

• Полная модель: S20B1A1EANS000
• Series and design: S20 metallic, design level 1
• Wetted material: aluminum
• Диафрагмы и контрольные шарики: Santoprene
• Check-valve seats: EPDM
• Non-wetted material: painted aluminum
• Liquid connections: 2-inch internal NPT
• Конфигурация: стандартный насос, без дополнительных наборов насоса или аксессуаров

Справочная информация о результативности

• Опубликованная максимальная емкость: 200 US gpm (758 L/min)
• Максимальное рабочее давление: 125 psi (8.6 bar)
• Максимальный размер взвешенных твердых частиц: 1/4 дюйм (6 mm)
• Air inlet: 3/4-inch NPT

These are the manufacturer's S20 metallic performance limits. Published curves use an elastomer-equipped pump with flooded suction and water at ambient temperature. Air supply, backpressure, suction conditions and fluid properties determine the operating flow. Maximum flow and maximum pressure are not a simultaneous duty point.

Выбор приложения

Consider this configuration for compatible water-based process fluids, industrial transfer and liquid-handling duties with small suspended solids. Evaluate aluminum, Santoprene and EPDM together against the actual process fluid. Do not assume suitability for oils, solvents, aggressive chemicals or hazardous locations from the pump's size or air-operated design.

Техническое обслуживание и запасные части

The manufacturer lists air-end kit 476-421-000 for the aluminum center and wet-end kit 476-042-354 with Santoprene diaphragms, Santoprene balls and EPDM seats. Confirm the full model and serial number before ordering. These service kits are separate maintenance items.

Before maintenance, isolate the air supply, release pressure and safely drain the liquid. Use the manufacturer manual for disassembly, inspection and reassembly requirements.

Запросить выбор насоса или предложение

Send the full model number, fluid and concentration, required flow and pressure, temperature, available compressed-air supply and connection details. For an existing installation, a readable nameplate photograph helps confirm the correct replacement configuration.

Manufacturer's S20 metallic series reference image. Exterior construction and materials may vary with the supplied configuration.